NOTE: Express orders - if need shipped out today, order must be placed by the following times:
UPS: 11:00 A.M. Eastern Time
FedEx: 11:00 A.M. Eastern Time
*Express shipping may not be available for all items
Features/Applications
The following switch is a hand operated, control circuit device, rated ‘Standard Duty’. The black plastic plunger is made from Lexan and the outer shell is brass.
· Slow Make – Slow Break Momentary Contact
· Nema 12/13, IP 65
The mechanical life of the switch is 500,000 operations.
This switch includes a cord grip and is often used as a circuit start switch wired to the end of a piece of SJO cable affording the operator greater flexibility in movement and vision.
The rugged construction and long term reliability makes this cable pull switch well suited to function within various environments.
Electrical Ratings
“STANDARD DUTY - B300 / P300”
Certified under CSA C22.2 – File # LR 3648
Environmental
Operating: +32oF to +131oF (0oC to +55oC)
Storage: -40oF to +185oF (-40oC to +85oC)
Note: Operating temperatures at 0oC are based on the absence of freezing moisture and liquids.
Normal Potential |
Normal Current |
Inrush Current |
110-120 aca volts |
3.0 amp. |
30.0 amp. |
220-240 aca |
1.5 amp. |
15.0 amp. |
440-480 aca |
|
|
550-600 aca |
|
|
115-125 dcb |
1.1 amp. |
----- |
230-250 dcb |
0.55 amp. |
----- |
a Power factor 0.35 or less
b Inductive loads as specified in Section 125 of Industrial
Control Devices, Controllers and Assemblies, ANSI /
NEMA ICS 2-1988
WARNING - DANGER
These products should only be used where point-of-operation guarding devices have been properly installed & maintained so that appropriate OSHA and ANSI B11.1 regulations & standards are met. Misapplication of the products on machinery lacking effective point-of operation safeguards can cause serious injury to the operator of that machinery.
---------------------------------------------------------------------------------------------------------------------
AVERTISSMENT - DANGER
Ces produit doivent seulement être utilisés sur des postes à risque correctement sécurisés et entretenus afin d’être conforme aux standards et régulations en vigueur (CSA, CLC). Un mauvais usage de ces produits sur des machines et des postes de travail non sécurisés de manière efficace peut causer des blessures graves au technicien maniant ces machines.