Call: 260.495.9811Email:

NOTE: Express orders - if need shipped out today, order must be placed by the following times:

UPS: 1:00 P.M. Eastern Time
FedEx: 12:00 P.M. Eastern Time
The following enclosures are made from 14 GA. sheet steel painted with a dry powder paint. The first group will accept all standard size REES push button switches. The second group (the 04938-’s) are designed to fit the larger style switches from page 18. The 02765-100 one opening, painted yellow, is suitable for holding an “Emergency Stop” switch. These enclosures can be used to house any switch that has the same mounting pattern.

These enclosures are rated Nema 12/13, IP 65.

Note: When mounting a Rees lockable switch on one of these enclosures you may need to order our gasket “spacer”, part number 01004-045, for additional room to add the lock.


These products should only be used where point-of-operation guarding devices have been properly installed & maintained so that appropriate OSHA and ANSI B11.1 regulations & standards are met.  Misapplication of the products on machinery lacking effective point-of operation safeguards can cause serious injury to the operator of that machinery.



Ces produit doivent seulement être utilisés sur des postes à risque correctement sécurisés et entretenus afin d’être conforme aux standards et régulations en vigueur (CSA, CLC). Un mauvais usage de ces produits sur des machines et des postes de travail non sécurisés de manière efficace peut causer des blessures graves au technicien maniant ces machines.

Unit of Measure


Number of Switch Openings

N/A 1 Standard

End Coupling Conduit Size

N/A 1" NPT


N/A Black

Approx. Shipping Weight

N/A 1.95 lb

Old Catalog Number

N/A 2765