Item # 03275-500, Rope Operated Switch (HEAVY DUTY - A600 / N300)

Features/Applications

This switch is a slack cable style with 2 NO and 2 NC “Snap Action” contacts.  This switch does NOT provide “Positive Break” or “Positive Transfer” features and should only be used for non-emergency, normal start – stop applications.

This low activating force switch is basically a pushbutton device operated through a nickel plated operating lever attached to the cover.  Care must be taken when choosing and installing the operating rope because the low operating force can be easily overcome and the switch will not trip or reset properly.

This switch requires a suitable enclosure which must be purchased separately.  One enclosure suggestion is Rees number 02765-000.  A sealing gasket and four mounting screws are supplied with each switch.

For complete assembly consisting of (1) 03275-500 and (1) 02765-000 sheet metal enclosure powder coat painted block, order part number 04956-300.

Each captive terminal will accept (2) #14 AWG stranded wires.

·        Low operating force

·        Gold plated contacts eliminate high resistance tarnishing

·        Positive Break contacts      

·        Nema 12/13, IP 65

The maximum recommended rope length is 33 feet with a maximum interval support of 10 feet when horizontal.

The mechanical life of the switch is in excess of 1,000,000 operations.

Electrical Ratings

“HEAVY DUTY – A600 / N300”

Listed under UL 508 – File # E 58589

Certified under CSA C22.2 – File # LR 3648

CE Compliant IEC/EN 60947-5-1

Environmental Temperature Range

Operating:  +32^oF to +131^oF (0^oC to +55^oC)

Storage:  -40^oF to +185^oF (-40^oC to +85^oC)

Note:  Operating temperatures at 0^oC are based on the absence of freezing moisture and liquids.

^a  Power factor 0.35 or less

^b  Inductive loads as specified in Section 125 of Industrial

   Control Devices, Controllers and Assemblies, ANSI /

   NEMA ICS 2-1988

WARNING - DANGER

These products should only be used where point-of-operation guarding devices have been properly installed & maintained so that appropriate OSHA and ANSI B11.1 regulations & standards are met.  Misapplication of the products on machinery lacking effective point-of operation safeguards can cause serious injury to the operator of that machinery.

---------------------------------------------------------------------------------------------------------------------

AVERTISSMENT - DANGER

Ces produit doivent seulement être utilisés sur des postes à risque correctement sécurisés et entretenus afin d’être conforme aux standards et régulations en vigueur (CSA, CLC). Un mauvais usage de ces produits sur des machines et des postes de travail non sécurisés de manière efficace peut causer des blessures graves au technicien maniant ces machines.