Features/Applications
The following switch is a hand operated, control circuit device, rated ‘Heavy Duty’ normally for use with electromagnetic equipment.  The body is made from die-cast zinc.  The flat plungers are made from red anodized aluminum.  This switch is particularly competent for use in Emergency Stop applications as well as for ordinary circuit control.  

• Key lockable when depressed
• Nema 12/13, IP 65
• Gold Plated Contacts

Each operator will accept up to three tiers of two contact blocks for a total of six separate blocks.  Each operator is supplied with all mounting hardware and a solid neoprene rubber gasket which provides an oil tight seal upon installation.  The mechanical life of this unit is 1,000,000 operations. 

Electrical Ratings
“HEAVY DUTY – A600 / N150”

 Environmental Temperature Range
Operating:  +32^oF to +131^oF (0^oC to +55^oC)
Storage:  -40^oF to +185^oF (-40^oC to +85^oC)
Note:  Operating temperatures at 0^oC are based on the absence of freezing moisture and liquids. 

^a  Power factor 0.35 or less
^b  Inductive loads as specified in Section 125 of Industrial Control Devices, Controllers and Assemblies, ANSI /NEMA ICS 2-1988

WARNING - DANGER

These products should only be used where point-of-operation guarding devices have been properly installed & maintained so that appropriate OSHA and ANSI B11.1 regulations & standards are met.  Misapplication of the products on machinery lacking effective point-of operation safeguards can cause serious injury to the operator of that machinery.

---------------------------------------------------------------------------------------------------------------------

AVERTISSMENT - DANGER

Ces produit doivent seulement être utilisés sur des postes à risque correctement sécurisés et entretenus afin d’être conforme aux standards et régulations en vigueur (CSA, CLC). Un mauvais usage de ces produits sur des machines et des postes de travail non sécurisés de manière efficace peut causer des blessures graves au technicien maniant ces machines.