Call: 260.495.9811Email: sales@reesinc.com
TERMS AND CONDITIONS

NOTE: Express orders - if need shipped out today, order must be placed by the following times:

UPS: 11:00 A.M. Eastern Time
FedEx: 11:00 A.M. Eastern Time
*Express shipping may not be available for all items

Features/Applications

The following guards are designed to mount to the single or double plunger push button switches.  They are die cast from a high strength zinc alloy (Zamac #3).

 

  • Additional length mounting screws are provided with each guard.
  • Series 09002 legend plates can be mounted on these ring guards. 

The usage chart below shows the minimum recommended guard to use to provide protection against inadvertent actuation caused by accidental contact of the switch plunger.  Use of a taller guard is an acceptable alternate method.

WARNING - DANGER

These products should only be used where point-of-operation guarding devices have been properly installed & maintained so that appropriate OSHA and ANSI B11.1 regulations & standards are met.  Misapplication of the products on machinery lacking effective point-of operation safeguards can cause serious injury to the operator of that machinery.

---------------------------------------------------------------------------------------------------------------------

AVERTISSMENT - DANGER

Ces produit doivent seulement être utilisés sur des postes à risque correctement sécurisés et entretenus afin d’être conforme aux standards et régulations en vigueur (CSA, CLC). Un mauvais usage de ces produits sur des machines et des postes de travail non sécurisés de manière efficace peut causer des blessures graves au technicien maniant ces machines.

Unit of Measure

Specifications

Color

N/A Painted Powder Yellow

Height

N/A 1.50 in
^