Item # 22102-504, Chrysler 22.5mm Landing Page

Available in Lockable, Push-Pull, and Momentary versions, the following switches are hand operated, control circuit devices, rated ‘Heavy Duty’ normally for use with electromagnetic equipment.  The body is made from die-cast zinc.  The mushroom shaped plungers are molded from DuPont Delrin 100ST Acetal for improved impact resistance and are solid colors throughout.

• Nema 12/13, IP 65
• Gold Plated Contacts

Each operator will accept up to three tiers of two contact blocks for a total of six separate blocks.  Each operator is supplied with all mounting hardware and a Buna-N (NBR) o-ring which provides an oil tight seal upon installation.  The mechanical life of these units is 1,000,000 operations. 

These devices can be found on a variety of machinery, used to perform such operations as ‘start’, ‘stop’, ‘top stop’, ‘inch’, ‘jog’, ‘on’, ‘off’, ‘forward’, ‘reverse’, etc.

The 22102 series satisfies the requirements of IEC 60947-5-5 – 3.9 direct opening action (positive opening action) (of a contact element); when one or more of any of our normally closed contact blocks are fitted on any red operator.  This is commonly referred to as “Positive Break”, meaning the breaking of the normally closed contact(s) is not dependent upon springs.

Includes Rees part # 01004-033 adapter to allow mounting in either a 30.5mm or 22.5mm opening.

Electrical Ratings

“HEAVY DUTY – A600 / N150”

Environmental Temperature Range

Operating:  +32^oF to +131^oF (0^oC to +55^oC)

Storage:  -40^oF to +185^oF (-40^oC to +85^oC)

Note:  Operating temperatures at 0^oC are based on the absence of freezing moisture and liquids.

^a  Power factor 0.35 or less

^b  Inductive loads as specified in Section 125 of Industrial

   Control Devices, Controllers and Assemblies, ANSI /